Backcountry guide · 4 min read

Planning portages and carries

A portage is rarely walked once. How many times you carry it, which way it climbs and the time spent loading at each end often matter more than its length.

On this page
  1. Follow the mapped portage
  2. Count your carries
  3. Read the climb both ways
  4. Loading at each end
  5. Checks on the line

On a canoe trip, the portages set the pace of the day as much as the paddling. This guide shows how to plan them in HuntGrid Backcountry: on the mapped trail, with the number of carries you’ll really make, the climb in each direction and the time it takes to load and unload the boat.

Follow the mapped portage

Draw a portage leg and snap it to a mapped portage, trail or access point. Each one names its source and date, and OpenStreetMap features are labelled apart from official ones. When a park publishes a portage’s length, the card shows it beside the length measured on the line you follow. Official park maps and posted signs control.

Count your carries

A single carry walks the portage once, with everything. A double carry walks it three times: across loaded, back empty, across loaded again. A triple carry walks it five times. Choose your carry style for the trip, and change it on any portage where you’ll carry differently. Loaded passes are timed at the pace for a full pack and empty ones at the pace for a light load, both from published walking-speed models.

Read the climb both ways

Each portage has an elevation profile. A loaded pass climbs what an empty pass descends on the way back, so each pass is timed on the profile in its own direction. The portage’s card lists its climb and descent beside its time range.

Loading at each end

Unloading the boat at a take-out and loading it again at the put-in take time of their own. The app adds your loading time once at each put-in and take-out stop on the route, never twice. A very short portage, a lift-over, counts only its loading. Loading time and the lift-over length are your settings: change them for the trip, and the passes for any single portage.

Checks on the line

A paddle leg drawn over land is flagged, so you can turn that stretch into a portage, and a hike drawn across water is flagged too. Mapped hazards near a paddle or portage leg, such as rapids and dams, show on its card.

See the trip planner. More about HuntGrid Backcountry.

Questions

Still have a question? Read the HuntGrid Backcountry help pages or email support@huntgrid.net.

Which carry style should I plan for?

The one you’ll actually use. If you’ll double carry most portages but single carry a short one, set the trip to double and change that one portage.

Does the app know how hard a portage is?

It knows the length, the climb in each direction and the source of the line. Mud, rocks and deadfall aren’t on the map: check the park’s maps and recent trip reports.

Your next trip starts on the map

Create a free account and open HuntGrid Backcountry in your browser. The same account works for every HuntGrid app.